|
»
|
Unit does not power on
|
|
Make sure FOUR (4) fresh batteries are installed with correct polarity. Or an AC/DC adapter 9-14V, center positive, is used.
|
|
»
|
Mount wobbling in AZ base/latitude adjustment
|
|
If it occurs in latitude adjuster, make sure the latitude lock screw is fully tightened. If it is in AZ panning base, you may tighten, but not over tighten the base with a flat tip screw driver. Or adjust the metal washers inside the bottom hole.
|
|
»
|
The brass mounting screw where a ball head is being attached is missing
|
|
The brass mounting screw may be dropped inside the RA compartment during shipping. Please remove the silver mounting block to recover it.
|
|
Products
